Finishing Line Division

How profitable an investment in production equipment has been will turn out when production figures are available. In output comparisons GEORG finishing lines have always achieved top values. This is the result from process controlled sequences, easy operation with a Minimum number of personnel as well as extremely short set-up times. We are ready to take over responsibility by a reliable partnership.

Scrap baller

The trimmed-off edge scrap is tightly rewound by the scrap baller. coil material like steel, stainless steel, aluminium, copper and their alloys with tensile strengths above 1000 N/mm² typical strip thickness range 0,1 – 4 mm typical trimming widths 3 – 50 mm location of scrap baller below floor level or on floor level with automatic start of seam windingscrap baller Design rigid base frame in welded steel construction as basis for drive unit, winding box and conical winding shaft running in roller bearings adjustable drive for winding of scrap coils with manual speed control winding box with rotating side discs and hydraulically operated pressure roller on top of the winding shaft which dives into the winding box to ensure a tightly wound scrap coil conical winding shaft mounted together with the drive unit on a hydraulically movable car on the same base frame; in order to catch the leading seam edge the winding shaft is designed with a slot push-out cylinder to eject the balled seam scrap coil into a scrap box survey of the winding process via camera and monitor